top of page
441.jpg

Step 1

Remove the M4 counter sink screw in front of the trigger guard.
Use a pin punch to remove the 3mm pin from the rear of the pistol, I have included a spare M3x35mm cap head, this can be used as a punch to remove the pin.

442.jpg

Step 2

Now remove the pistol grip and trigger guard as one piece.

444.jpg

Step 3

Now fit the HW44 action into the stock and fit the new M3x35mm cap head bolt (not the one that was used as a pin punch) dont  fully tighten this screw just yet.

445.jpg

Step 4

Now fit the original M4 counter sink and fully tighten, then tighten the M3x35mm cap head screw. 

Please do not over tighten either of these screws

Screenshot 2025-05-27 152302.png

Fitting the buttpad
(Folding stock)

Position the thumbscrew in the
cut out on the rear of the stock.
The bolt needs to be angled as shown.

Offer up the buttpad and fix with
the thumbscrew. Ensure the red fibre
washer is positioned as shown

bottom of page