Bob Pattenden
3D printed stocks and shooting accessories
Website Update
Thanks for all the support over the years.
For now, I’ve decided to pause making and selling the 3D printed stocks shown on this website. I’m still active selling smaller items in my Ebay shop, so this isn’t necessarily permanent — I may return to stocks in the future.
I’ll be keeping the site online as a gallery of past work and for any future updates.
Thanks again for your support and understanding.
CP2 adjustable cheekpiece
Step 1
Fit the main mounting section inside the CP2 stock, it will only fit one way, this can be verified by ensuring the 6mm cross hole is uppermost and the small single indent on top of the mount is towards the rear of the stock. This should be a nice snug fit.
Step 2
Next drop the cheek section over the CP2 stock and locate on its sliding rails. Gently clamp this in place with the two thumb wheels through the 6mm cross hole.
Step 3
Next fit the 4 clamp lugs to lock the main body to the CP2 stock, M5x40mm counter sink screw to the rear of the stock and M5x35 counter sink screw to the front of the stock. Only need to nip these up.
Step 4
Finally adjust the cheek piece to suit your eye alignment. The locking thumb wheels only need to be nipped up to hold the cheek piece securely.
Enjoy !
